Previous
Next

Livraison offerte dès 89€ d'achat en point relais

Titling system for Knife Maker's Backstand MV2020-1

Michel Vaillant
0/5
This system allows the Backstand Knife Maker MV2020-1 to be tilted to work flat. (Horizontal handrest table).
The complete system is mounted in replacement of 4 pre-existing fixing screws. The mounted backstand can be tilted at 90° by simply unlocking a screw handle. Pre-positioning vertical or horizontal is done in a stop on one side or the other. The feet attach to the base plate, which is also pre-drilled to accommodate the system.
Comes with 280mm wide orbital hand rest table with wheel notch 100 and 300 of diameter.
Référence : INCLINAISONTRAVAILHORIZONTAL
€438.00
€525.60
Tax included
En stock
Ajouter au panier
Partager
Facebook Twitter

Partager le lien

Backstand tilt optimization

The 80mm machine elevation has been implemented to ensure a smooth tilt of the backstand without the motor encountering the ground, which can potentially damage the machine or lead to premature wear. This technical change is intended to improve the durability of the equipment and ensure smooth operation. However, it's important to understand the impact of this elevation on your work process.

Adaptation of the Working Position


With this 80 mm rise, it is necessary to anticipate an adjustment of your working position. It can be helpful to rethink work methods and ensure that elevation does not affect the workability or quality of the accomplished work.

Delivered with 280mm wide orbital hand rest table with wheel notch of 100 and 300 diameter.

Backstand tilt optimization

The 80mm machine elevation has been implemented to ensure a smooth tilt of the backstand without the motor encountering the ground, which can potentially damage the machine or lead to premature wear. This technical change is intended to improve the durability of the equipment and ensure smooth operation. However, it's important to understand the impact of this elevation on your work process.

Adaptation of the Working Position


With this 80 mm rise, it is necessary to anticipate an adjustment of your working position. It can be helpful to rethink work methods and ensure that elevation does not affect the workability or quality of the accomplished work.

Delivered with 280mm wide orbital hand rest table with wheel notch of 100 and 300 diameter.

Brand
Category Backstand Brand Michel Vaillant

Les avis sur notre produit

Comments (0)

Vous aimerez aussi...

Voir les déclinaisons
Plaque d’appui orientable...

Plaque d’appui orientable pour Backstand Coutelier MV2020-1

Michel Vaillant

The contact wheel is an additional tooling for the Backstand Knife Maker MV 2020-1. Provided with a vulcanized caoutchouc coating around it, with a hardness of 70 Shore D. If necessary, it can be provided with a notched coating, except the 38 mm version. This wheel is assembled on a high-speed precision ball bearing and can be directly installed to replace the planning table.
€200.00 €240.00